Realtek 8139D chipset
10/100Mbps supported data transfer rates
Automatically senses media type
Full Duplex Ethernet support
Automatic configuration through PCI BIOS
Programmable PCI burst size
Provides 32-bit Bus Mastering data transfers
Diagnostic Link and Activity LEDs
Supports flow control
PCI 2.2 compliant
Supports ACPI and PCI power managment
IEEE802.3 and 802.3u standards
Supported Networks and OS's:
Novell Netware 3.12/4.0/5.0
Microsoft Windows NT 3.5/4.0
Microsoft Windows 95/98/2000/ME/XP
IBM PCLAN Program (NetBIOS)
TCP/IP for SCO UNIX
FTP TCP/IP, NCSA TCP/IP
Gigabit Network Card
Integrated Gigabit Ethernet PHY and MAC functions; Full/half-duplex and 10/100/1000 Mbps triple-speed operations support
IEEE802.3ab Auto-Negotiation support
Automatic detection and correction of cable pair polarity, along woth Auto MDI/MDIX cable crossover or pair swap detection
IEEE 802.3x compliant flow control support for full-duplex operation;Collision-based back-pressure support for half-duplex operation
IEEE 802.1p Priority Queuing support with 4 classes of priority queues
IEEE 802.1Q virtual LAN(VLAN) support with 63 BLAN tags
64KB deep on-chip Rx and Tx packet buffer
IPv4 TCP, IP and UDP checksum off-loading capability over Rx and Tx
IPv4 TCP segmentation off-loading capability over Tx
Jumbo frame support up to 16KB
Adaptive interrupt
Ring type packet-descriptor management circuit; Support multiple packet-descriptor fetching in a single burst
Entering Power Saving mode by automatic link speed switching from 1000Mbps down to 10 or 100Mbps in standby
Wake-up from Pre-ACPI and AbnormalShut-Down
Hardware and sofrware counters support for traffic statistics gathering
DMI 2.0(Destip Management Interface), WfM 2.0(Wirec fo management) compliant
Advanced packet filtering
Provide analysis tooling for 1000Base-T type ling over its link quality, cable diagnostics, cable loss, return loss and NEXT loss
One built-in RJ-45 connector
Two LED indicators: Link/Activity
Driver supprot for: MS Widow server 2003/XP/NT/ME/2000/98SE, Read Hat Linux 7.3(kernel 2.4.18-3) or later, Novell Netware 4.2/5.x/6.x/ODI 1.11
Ultra ATA133 IDE RAID PCI Controller Card IT8212F Chipset
Brand New In Package
Specification:
Compliant with UDMA5 ATA/100 or UDMA5 ATA/133 specification
Compliant with ATA/ATAPI-5 or ATA/ATAPI-6 specification
Suppoorts maximum data transfer rate of 100MB/sec or 133MB/sec
Compliant with PCI IDE controller speciofication REvision 1.0
Compliant with programming interface for Bus Master IDE Controller Revision 1.0
Two independent Ultra ATA Channels with 128/256 bytes buffer per channel
Connect up to four IDE/ATA devices (Coexist with on-board IDE ports)
Compatible with Microsoft IDE/ATA drives
Modem Feature
Automatically detects all ITU V.92, V.90 ,K56 Flex or 33.6Kbps connection (Dual Mode)
Smart DAA technology
Line-in-use detection
Remote Hang up
Extension off-hook detection
Calling waiting
Digital PBX line protection
Wake-on ring filtered in hardware
Enchanced voice features
Extension pick-up detection
Line-in-use;stop recording TAM message
Data/Fax/Voice call identification
Full-duplex speakerphone
Hardware based DSP (Digital signal processor)
Fax/Voice Mail Features
Automatically detects and routes incoming voice,fax,and data call to the proper module
Fax speed up to 14,400bps
Sends and receives faxes to or more any group 3 fax machines
Printer-quality faxing, forwarding
Schedules fax transmission and multiple recipients
Convenient voice storage and playback
Easy voice message retrieval through sound card, or from remote locations
Password protection for up to 999 mail boxes
System Requirements
P3 300 or above CPU
64MB RAM
One available PCI Rev.2.1 Compliant Slot
Microsoft Windows 98/ ME/ 2000/ XP
CD ROM drive required for software installation
Dual PCI bus 9-pin High Speed 16550 UART serial port
- adds two additional COM ports to any PCI equipped PC.
Maximum data throughput rate: 115.2k bps on each port.
Both ports share one IRQ
- even when accessed simultaneously . Saves valuable resources for other expansion cards.
Easy Plug and Play installation
- automatically configures next available COM address and IRQ.
Includes Lava COM Port Redirect Utility for renaming COM Ports
- allows for backward compatibility with software that supports COM 1
Fully compliant with PCI specification 2.1
Sunix Chipset
PCI 2x6p+1x4p+1x(internal) Firewire Card
USB Features:
USB(Universal Serial Bus) 1.1/2.0 Specification Compatibility.
Compatible with OHCI(Open Host Contrller Interface).
Hot-Swappable and real Plug & Play capability.
Provides two downstream ports with root hub function.
Connects up to 127 devices in a tiered star configuration.
Each port works with full speed(12Mbps) and low speed(1.5Mbps)devices.
Supportsindividual port over-current and inrush current protections.
Provides Bus fault detection and reconfiguration.
PCI interface specification V.2.1 compliant.
1394
1394 standards compliant IEEE 1394-1995,P1394a (rev.1.1) and
OHCI (rev.1.0).
Data transfer:Asynchronous and isochonous data transfer at
100/200/400Mb/s data rate.
Hot plugging,dynamic reconfiguring of up to 63 nodes on the
bus,no need to turn off the system while adding or removing
1394 devices.
3 fully independent ports to provides maximum peripheral
connections.
PTC resettable fuses for reliable overcurent protecion.
PCI 3+1 Firewire card
Firewire 1394 features
1394 standards compliant IEEE 1394-1995,P1394a (rev.1.1) and
OHCI (rev.1.0).
Data transfer:Asynchronous and isochonous data transfer at
100/200/400Mb/s data rate.
Hot plugging,dynamic reconfiguring of up to 63 nodes on the
bus,no need to turn off the system while adding or removing
1394 devices.
3 fully independent ports to provides maximum peripheral
connections.
PTC resettable fuses for reliable overcurent protecion.
** PCI Multi-I/O Expansion Card with 1 Parallel Port & 2
Serial Ports **
Adding additional connectivity to serial and parallel
devices is simple with this PCI I/O card.
Simply plug this card into any available PCI slot, and instantly
gain an additional parallel port for printers, older
scanners or any device that requires a parallel port.
Attach the included serial port backplane to the
headers on the card, and have access to two 9-pin
standard serial ports. This is packaged in a plain
white box.
--> General Features:
- PCI I/O expansion card
- Adds one 25-pin standard ECP/EPP/SPP parallel port
- Adds two standard (RS232) 9-pin serial ports via onboard
headers and included backplane adapter
- Adding this card will not disable any existing serial or
parallel ports already in your system
- Windows 95/98/ME/2000/XP
--> Package Includes:
- PCI I/O card
- Serial ports backplane adapter
- Drivers CD
- Users Manual
